Multi-Unit Abutment Machining Fixture

Digital Fabrication

Easy, Accurate and Rigid Multi-Unit Fixture The latest version of our NT-Abutment cartridge for the VersaMILL 5X introduces many advantages and improvements over standard products.

Our abutment manufacturing system utilizes the same base fixture utilized for zirconia cartridges. This time and money saving approach, coupled with the ability to easily swap between the VersaMILL’s dual coolant tanks makes transitioning between machining titanium abutment blanks and zirconia easier than ever.

The abutment cartridge mounts directly into the standard VersaMILL 5X fixture so there is no need for technicians to go through a complicated and lengthy calibration routine.

The abutment cartridge mounts directly into the standard VersaMILL 5X fixture so there is no need for technicians to go through a complicated and lengthy calibration routine.

Additional System Features: Highly accurate one piece design minimizes stacked tolerances Cartridge is finished machined directly on each mill ensuring positional accuracy without complicated setup Fully compatible with NT-Trading abutment inserts, analogs, and blanks Alignment pins ensure repeatable accuracy Sub-30 Micron repeatability possible Blank is fully supported by both the analog and tailstock greatly improving rigidity and surface finish Tailstock is designed so that any rotational forces induced during milling are NOT applied directly to the interface Modular design allows labs and milling centers to mix and match different size abutments and platforms in a single setup