- Matt Paton · Mar 27, 2014
I recently purchased 2 Jelrus Infinity L30 burn out ovens on E-bay, one used one new. The used performed well for about three months. After three months the display would not ligth up but you could hear the oven heating. After reading all the tech bulletins and manuals the recommendation was to...
Read More 1 minute readMatt Paton · Apr 30, 2013
I read an article about placing patient identification in acrylic dentures. May labs were discussing the best way to cold cure the ID into the denture and what materials to use for the actual ID. I heat cure the denture ID into the denture and it will never yellow or fade. Here's how,
Read More 1 minute read
I visited a friends full service lab and the monomer fumes hit like a brick wall. To all of the denture technicians...how do you control the air quality in your lab?
1. Make sure you store opened containers and acrylic mixing bowls in a dark airtight...See more or as close as possible storage cabinet.
2. When mixing any monomer use a venting hood with a charcoal barrier. the mixing should take place in the immediate area so the fumes are drawn through the charcoal....or vent to the outside.
3. When processing place your processing equipment under a powered vented hood.
4. When disposing of old acrylic. rags, empty monomer bottles or any other item that may be contaminated take them directly outside to the trash or dumpster.
5. If you have a spill be sure to get everything clean and thrown out or washed.
When all these steps are followed you should have a minty fresh lab!
I have been in removables for 16 years. I have the same outlook as you.....love to see...See more the smile when it's all done right....from the patient and the dentist!
Ahh, the all nighter....been there done that! Some how the deadlines always get met. My kids grew up...See more in a dental lab too. Nice job Jessica. I am recently back from Afghanistan. Had a lab 18 years ago. Decided to reopen another after all this time. I look around and think if my accounts ever saw where I made choppers they would flip. Hope fully I will build a new addition next year and get above ground.
Continued success to you! — tagged Home-Based Labs
"Being in the foxhole together is not just a partnership; it's the essence of collaboration. For it to work, dentists and technicians must truly understand each other's challenges and goals. That's when you see the best possible results and the most satisfied patients." – Terry Fohey, CDT
LMT Original Research © 2010 - 2015